EXPI/O-2

EXPI/O-2 blocks are similar to CobraNet Input and CobraNet Output blocks, except they are designed for use with AudiaEXPI/O-2 hardware specifically and, therefore, automatically allow for Internal Propagation Delay. CobraNet Input blocks may be used with AudiaEXPI hardware, but Internal Propagation Delay must be manually set (1.00mS for input blocks/0.33 mS for output blocks).

Adjust input trim (gain) controls so that Peak In flashes only occasionally (6dB headroom). Mute In turns the input signal on/off. Level In adjusts the relative input volume. Invert In reverses the polarity of the input signal.

Mute Out turns the output signal on/off. Level Out adjusts the relative output volume. Invert Out reverses the polarity of the output signal.

CobraNet Bundle assigns digital audio data to a particular bundle number. CobraNet® Bundle Numbers are used to match those of the actual AudiaEXPI/O-2 hardware being used in the system. Normally, 'unicast' bundles 256 ~ 61,439 are selectable. These are device specific bundles (for exchange of digital audio with only one other device). Multicast allows selection of bundles 1 ~ 255, which are not device specific (for exchange of digital audio with multiple devices). Enable turns on/off the exchange of CobraNet digital audio data from this device.

Right-clicking over certain settings will provide a menu of additional options.

The bundle number of an EXPI/O-2 input and output block need to be different from each other in order for audio to pass correctly.